ZeroDrift":1kwg0t0b said:Must say they work quite well- however with the low amp draw these have, the MR2 no longer has an operational hi-beam indicator lamp.
FC Zach":1kwg0t0b said:Wonder how that can be corrected? ?
801Alltrac":1kwg0t0b said:OMG that looks great, great work FC Zach
I knew they would look great, I wonder if there is a resistor would work
FC Zach":1kwg0t0b said:I'm wondering if I could measure and record the ohms with the factory and new light installed then just buy a resistor sized close to the difference of the two? Does that make any sense? (It does in my head lol) Then do I just simply install it inline on the high beam wire?
801Alltrac":1kwg0t0b said:That's what I think would work
MWP":1kwg0t0b said:It wont.
You'll need to rewire the light in the dash.
What I did to fix this little issue: Instead of using a resistor I simply attached a small 194 bulb to each light.
fussellbug":qwo4q8xf said:What I did to fix this little issue: Instead of using a resistor I simply attached a small 194 bulb to each light.
Did you put the 194 bulb in series or parallel? Where did you physically put the bulb?
underscore":keame8qb said:Zach, what did you mount those LED pods to? The little tabs above those slots on the bumper cover or somewhere else?
underscore":1douyob6 said:Any chance you have pictures? When I'm looking around back there I see a whole lot of nothing nearby.