hello, i purchased an st165 a few month ago, not running fixed some issues here and there, clocked turbo correctly it had an st185 turbo ser up on factory st165 engine with a bunch of AN fittings, leaked everywhwre did not spool, waastegate actuator wasnt on right. clocke turbo, modified actuator, so that explains code 34 over boost.
my other issue now is, u try to start the car, hold the key takes a while at least 25-30 seconds to start idles up at 1400-1500 just fine, but the minute u blip the throttle it will sound like its about to shut off and when u let it go it idles again, if u hold the throttle down over 20% it will cause this issue, if u barely touch the throttle 10-15% it will rev up smoothly.
basically its heaitating under throttle, hot or cold it will cause this issue, i put new cap rotor, same plug wires and plugs, new oil in engine and coolant flush since it was rusted, flushed water pump for turbo and for engine. ideas? i bought a spare distributor and i also switched coil pack with a good working 1. i did not use new distrubtor yet.
i also, did not ignition time the motor yet, but i know this code 11 isnt from that.
my other issue now is, u try to start the car, hold the key takes a while at least 25-30 seconds to start idles up at 1400-1500 just fine, but the minute u blip the throttle it will sound like its about to shut off and when u let it go it idles again, if u hold the throttle down over 20% it will cause this issue, if u barely touch the throttle 10-15% it will rev up smoothly.
basically its heaitating under throttle, hot or cold it will cause this issue, i put new cap rotor, same plug wires and plugs, new oil in engine and coolant flush since it was rusted, flushed water pump for turbo and for engine. ideas? i bought a spare distributor and i also switched coil pack with a good working 1. i did not use new distrubtor yet.
i also, did not ignition time the motor yet, but i know this code 11 isnt from that.