So today I had to upgrade the fuel pump wiring to a 10 gauge wire. My car wouldn't start this morning due to no fuel. Efi main fuse, 15A, didn't look so good... (Plus fuel pressure gauge was not increasing when key switched on to prime and couldn't hear fuel pump) (edit: as in signature, not a stock ecu)
https://photos.app.goo.gl/kRBJuQRGue6e2WV28
Fuse box part was a little melted too but not bad. Swapped hazard fuse into it's place and stayed out of boost till I could get to the shop. Made it without issue and installed a new fuse. Ran the new 10 gauge wire down through harness hole and along passenger kick panel area, along passenger side panels by rear seat, into spare tire well, and finally to relay. Using a 25A fuse (walbro 450 pump can draw up to 22.5A according to website). Hopefully if anyone else needs to do the same this will help! Good luck! Feel free to ask any questions.
https://photos.app.goo.gl/o7txgEVGag5Mfcan8
https://photos.app.goo.gl/5Myj4zTguwSPBhS69
Also added the Amazon motortrend cargo liner with quick rough trimming until I can cut out a pearce of wood or something for a proper floor.
https://photos.app.goo.gl/oiCmcd4VAY6JVUx88
https://photos.app.goo.gl/kRBJuQRGue6e2WV28
Fuse box part was a little melted too but not bad. Swapped hazard fuse into it's place and stayed out of boost till I could get to the shop. Made it without issue and installed a new fuse. Ran the new 10 gauge wire down through harness hole and along passenger kick panel area, along passenger side panels by rear seat, into spare tire well, and finally to relay. Using a 25A fuse (walbro 450 pump can draw up to 22.5A according to website). Hopefully if anyone else needs to do the same this will help! Good luck! Feel free to ask any questions.
https://photos.app.goo.gl/o7txgEVGag5Mfcan8
https://photos.app.goo.gl/5Myj4zTguwSPBhS69
Also added the Amazon motortrend cargo liner with quick rough trimming until I can cut out a pearce of wood or something for a proper floor.
https://photos.app.goo.gl/oiCmcd4VAY6JVUx88