hey guys, been working on getting my 1990 GT-FOUR running, its a 3RD gen swap, and im using a MSPNP2 (TS9092) and the original gen 2 harness, got everything back together now but the car is only running on cylinders 1 & 2, #3 / 4 are getting spark but no fuel, is this an issue with the ECU im using? 1990 JDM ecu pinout should be the same as 90-92 USDM ecu? is the reason im not getting fuel possibly because of the injector resistor pack going bad? how do i test the resistor pack? not sure what to do, its probably something simple but i really dont know anything about electrical stuff, i unplugged injector #4 and used a voltmeter and it gets 12volts but i dont know if it is being signalled to inject, i cranked the car for a while with the coil disconnected and plugs 3/4 were dry.